Find my fader / DJ Tech
Install details

DJ Tech DIF-1S

Channel faders
See crossfader details
Buy Innofader Pro2 →

Detailed installation

For the Innofader Pro2, please loop both ends of the 3 wire cable on adapter (15) to keep the exposed 3 pin connectors from short circuiting. Use the Allen and Heath Xone:22 cable to connect from the PC board 2x5 header (10 pins total) to the crossfader connector on adapter (15). Then connect the 2 wire cable from the "POWER I/O" connector to the 2 pin connector on the DIF-1S PC board next to the line fader.

One issue with this installation is since the power goes straight to the Innofader Pro2, this may result in high pitched noise. Adding a 160 ohm resistor in series with the red wire will eliminate the noise.

← Search another mixer