The installation process is almost the same as the one for the
vmc 002 except that the 2pin connector that goes from the power board to the non vca adapter is a little bit too short. To make sure the fader fits, you have to cut the connector and make the cable longer with some wires.
The one you need for the inno is the one in the upper pcb in the very left corner, in front of it is a little blue component.
Note the Innofader Pro2 has significantly less noise than the Innofader Pro. Regardless, if you still run into issues with audible noise getting into the output, please check the following
forum post.