Note for the Nuo 2.0, there is an issue with the crossfader being a bit slow. You can fix this issue by replacing two capacitors on the front panel PC board. First locate the component area:

Then replace the two circled capacitors with two 0.01uF capacitors in a 0805 SMD package rated for 6.3V minimum.

Replacing these components changes the circuit response time from 20 milliseconds to 1 millisecond. Nice!
For the Innofader Pro and Pro2:
Make sure you use the insulated screws and washers during installation as shown
here.
For the Innofader Pro2: If you wish to install the Innofader Pro2 for channel faders, please use the POWER I/O connection as shown in Figure 12
here.
For the Innofader Pro: Please do the
Ecler Eternal Installation mod fix For channel fader installation, the original Innofader includes special circuitry for allowing a 3 Innofader installation in this mixer as shown
here.
For the original Innofader: Use the ECLER ETERNAL ADAPTER.