***PURCHASE AN INNOFADER:*** |
|
|
FADER SLOT: Crossfader Only |
_______________________________________________ |
|  |
| SUGGESTED HEIGHT ADJUSTMENT: Lower by 0.5mm.
More info |
| ADAPTER BOARD (included): Adapter (3) |
| OPTIMAL CURVE DIAL SETTING: 12:00 |
| |
_______________________________________________ |
Installation Notes: |
| Fader body and adapter must be fully isolated from internal circuits with insulating screws and insulating washers. |
Installation Detailed Description: |
The EVO4 is one of the few newer Ecler models which uses the old 3 wire connector for the crossfader and is not one of their Eternal fader compatible mixers. The Innofader Pro or Pro2 is required for proper crossfader operation since the reverse switch reverses power to the crossfader.
Please also make sure to isolate the Innofader circuitry from the mixer as shown here: Innofader electrical isolation |
