Use included flathead screws for more headroom between the mixer faceplate and the crossfader plate.
Multiple Innofader models will work for this mixer. The preferred model is listed first based on the best performance / cost tradeoff.
Use 1.2mm raised cap to prevent the knob from scraping against the faceplate (full bodied Innofader models only)
Also fits the original Innofader Pro. Please follow the instructions for VCA hookup
Detailed installation
Please check the Mechanical Fitting instructions for increasing the stem height. Note on the Innofader PNP and mini Innofader PNP P that the right 3 pins of the 3 pin small cable are used which is illustrated here. Otherwise the Innofader Pro2 uses adapter (5) and the Innofader Pro uses the J43 socket.