***PURCHASE AN INNOFADER:*** |
|
|
FADER SLOT: Crossfader |
Please see here for channel fader details. |
|
_______________________________________________ |
| |
ADAPTER CABLE: 4 pin large. Reversing cable will reverse output. |
OPTIMAL CURVE DIAL SETTING: 12:00 |
SPECIAL Y CURVE SETTING recommended for crossfader installation. More Info |
|
_______________________________________________ |
| |
ADAPTER BOARD (included): Adapter (1) |
OPTIMAL CURVE DIAL SETTING: 12:00 |
SPECIAL Y CURVE SETTING recommended for crossfader installation. More Info |
|
_______________________________________________ |
| |
SUGGESTED HEIGHT ADJUSTMENT: Lower by 5.0mm.
More info |
ADAPTER CABLE: 4 pin large. Reversing cable will reverse output. |
|
_______________________________________________ |
Installation Notes: |
Multiple Innofader models will work for this mixer. The preferred model is listed first based on the best performance / cost tradeoff. |
Also fits the original Innofader Pro. Please follow the instructions for VCA hookup |
Installation Detailed Description: |
All of the standard Innofader models - Innofader Pro2, Innofader Pro, Innofader PNP, mini Innofader PNP P - will work. A few things to note:
1) The Innofader PNP and mini Innofader PNP P outputs are limited to 0 to 5 volts, so when using the softest mixer curve, you won't get full mixer volume. 2) Some older Vestax PMC models MKII or earlier have an issue with the Innofader PNP where the following mod is needed to make the fader fully cut out on a sharp curve:Fix for Bleeding or Decay.
Note the Innofader Pro2 now can be used for all 3 Vestax faders without mods. Please refer to figure 12 showing the power hookup. |