Find my fader / Allen and Heath
Install details

Allen and Heath Xone:42

Crossfader only
Buy Innofader Pro2 →

Installation notes

  • Requires adapter plate included with the Innofader kit

Detailed installation

The Xone:42 will work using the Innofader Pro and Pro2 only. On the Innofader Pro, use the J40 socket and make sure you set "SOURCE: EXT INT" to "INT" first.

Note you will need to modify the actual mixer to make the installation work properly. Without the fix the outputs will bleed regardless of how you adjust the Innofader.If you have a soldering iron, you can simply short out R126 which is a 100 ohm resistor. Please see the picture below which marks this resistor.If you don't have a soldering iron, adjust VR5 inside the Xone:42 until you eliminate the bleed on both CH1 and CH2.If you have done this installation, please email pictures to support@audioinnovate.com

← Search another mixer