***PURCHASE AN INNOFADER:*** |
|
|
FADER SLOT: Crossfader Only |
_______________________________________________ |
|  |
| ADAPTER BOARD (included): Adapter (15) + A&H Xone:22 cable |
| USE 8 PIN NOISE FILTER CABLE (included): More info |
| ADAPTER EXTERNAL POWER: Please see Innofader Pro2 Instructions
|
| OPTIMAL CURVE DIAL SETTING: 12:00 |
| |
_______________________________________________ |
Installation Notes: |
| Requires wiring modification using mini flathead screwdriver included with the fader. Please see mixer specific instructions for more detail. |
| Please also order the Innojuster to get a full range of curves. |
Installation Detailed Description: |
| A special crossfader cable is included with both the Innofader Pro and Innofader Pro2 for installation in the Xone:22 mixer. The installation does require some pulling wires in and out of connectors, and the faceplate is a bit of a challenge to remove and put back on, but the installation is definitely doable without any soldering, wire cutting, or hole drilling mods. Here are the Xone:22 Innofader Pro installation instructions |
