DO NOT USE THE ORIGINAL INNOFADER OR INNOFADER PNP ON THE XONE:02!!! We've had many reports of product failures since the reverse switch gets shorted out by the original Innofader. The Innofader Pro and Pro2 resolve these issues.
The Innofader Pro also has a switch marked "SOURCE: EXT:INT" Make sure this switch is set to "INT" which is the default setting.
The "Y" setting means remove the jumper marked "X/Y" on the fader. On the Pro2, please use the Y curve preset
here and
here. This will allow you to adjust the left and right channel outputs independently.
Just one unusual thing about the way this mixer works is that the curve adjustment is backwards. So if you want the Innofader itself to have a sharper curve than normal, make sure you soften rather than the curve on the Innofader.
The mechanical fitting for this mixer is fairly straightforward. The Innofader mounts exactly where the original Xone:02 fader was installed.