***PURCHASE AN INNOFADER:*** |
|
|
FADER SLOT: Crossfader |
Please see here for channel fader details. |
|
_______________________________________________ |
| |
SUGGESTED HEIGHT ADJUSTMENT: Lower by 0.5mm.
More info |
ADAPTER BOARD (included): Adapter (9) |
OPTIMAL CURVE DIAL SETTING: 12:00 |
|
_______________________________________________ |
| |
ADAPTER CABLE: J8. ***Polarity Test Required***. |
OPTIMAL CURVE DIAL SETTING: 12:00 |
|
_______________________________________________ |
Installation Notes: |
Fader body and adapter must be fully isolated from internal circuits with insulating screws and insulating washers. |
Use 1.2mm raised cap to prevent the knob from scraping against the faceplate (full bodied Innofader models only) |
For all Pioneer Magvel replacements using the Innofader PNP3, please see the precision mode adjustment video and/or the precision mode adjustment manual. This adjustment is necessary to get the Innofader PNP3 working properly as a Magvel replacement. |
Installation Detailed Description: |
For the Innofader Pro and Pro2: Make sure you use the insulated screws and washers during installation as shown here.
For the Innofader Pro2: If you wish to install the Innofader Pro2 for channel faders, please use the POWER I/O connection as shown in Figure 12 here.
For the Innofader Pro: Please do the Ecler Eternal Installation mod fix For channel fader installation, the original Innofader includes special circuitry for allowing a 3 Innofader installation in this mixer as shown here.
For the original Innofader: Use the ECLER ETERNAL ADAPTER.
|